NT RG - 108
REGULATOR CLUSTER
SOLAR PANEL (12V-10A)

These NT RG - 108 regulator is tasked with keeping the power of a system to always function in a long time, function of the regulator of this cluster is to control the charging process (charge) and use (discharge) batteries, the regulator is set when
the charging process batteries do, when to stop and when to use battery,
so batteries can last a long time.

These regulators have the following specifications:
Charge Limit
- Batteries > 13.80 Volt
- Current > 10 Ampere
- Temperature > 45° C

Batteries charging process of the solar panel (through the regulator) batteries performed when the voltage does not exceed 13.80 volts and the current does not exceed 10 amperes and temperature regulator does not exceed 45° C.

When the voltage (volts), current (amperes) and temperature (temperature) on the verge of the limits specified, then the regulator will stop the charging process batteries.

Protect Over Discharge:
- Batteries < 10.25 volts
- Load > 10 amperes

Price: Call

Regulators will stop the process of use (load) batteries, when power is needed more than 10.25 amperes. The process is stopped when voltage usage is also batteries less than 10.25 volts, and will start again when the voltage reaches 12.25 volts batteries (increased due to the charging process).

SPECIFICATIONS
Rated voltage 12V
Automatically distinguished voltage
Loading current max 10A
Full charge cut >13.80V
Reconnected charge <13.60V
Low voltage cut <10.25V
Reconnected voltage > 12.25V
Temperature max cut 45o C
Wire area minimum 4mm2
Display LCD 8x2 characters
Current display yes
Voltage display yes
Consumption display yes
Temperature display yes
Contrast LCD yes
Bottom display ON/OFF yes
Bottom bypass yes
Bottom reset yes

Back to Products